Electrode Setting; Update Software - INNO VIEW 5 User Manual

The splicer will show up two values on the screen after each arc calibration. If
•
the value shown on the right-hand side meets 11±2, the message "Operation
Complete" will be shown on screen. Otherwise, set prepared fibers on the splicer
again and redo arc calibration until the message "Operation Complete" is
displayed.

Electrode setting

Set the electrode change warnings.
electrodes every 3500 discharge to ensure the best splice results.
Select [Electrode Setting] in [Maintenance Menu].
•
Set the electrode caution and electrode warning.
•
Parameter
Electrode Caution
Electrode Warning

Update software

Select [Update Software] in [System Setting].
•
Connect the USB driver with the copy of upgrade files to the USB port.
•
Press "OK", and then the splicer will process the update automatically. Upon
•
completion, the splicer will restart automatically.
Chapter 7 Maintenance Menu
INNO Instrument
If actual arc discharge exceeds the set value, a message "Caution! Replace
Electrodes" is displayed when turning on the splicer.
recommends that this parameter should be set to "3500".
If actual arc discharge exceeds the set value, a message "Warning! Replace
Electrodes" is displayed when turning on the splicer.
recommends that this parameter should be set to "5000".
recommends replacing the
Description
INNO Instrument
INNO Instrument
39