The User Screen; The User Add/Modify Screen - ZyXEL Communications GS1900-8 User Manual

Table 163 Configuration > Management > SNMP > Group > Add/Modify (continued)
LABEL
Apply
Cancel

31.3.6 The User Screen

Use this screen to view the User settings. Click Configuration > Management > SNMP > User
to open this screen.
Figure 198 Configuration > Management > SNMP > User
The following table describes the labels in this screen.
Table 164 Configuration > Management > SNMP > User
LABEL
SNMP User
Add
User Name
Group
Privilege Mode
Authentication
Protocol
Encryption
Protocol
Access Right
Action
Delete

31.3.7 The User Add/Modify Screen

Use this screen to configure the User settings. Click Configuration > Management > SNMP >
User > Add/Modify to open this screen.
Chapter 31 Configuration: Management
DESCRIPTION
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Click Add to create a new SNMP user.
Displays a string identifying the user name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Displays a string identifying the group name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Displays the privilege mode that this entry belongs to.
Displays the authentication protocol that this entry belongs to. Possible authentication
protocols are:
• None: No authentication protocol.
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means
you must first ensure that the value is set correctly.
Displays the encryption protocol that this entry belongs to.
Displays the access mode for this entry. The possible values are Read-Only and Read-
Write.
Click Delete to remove the entry.
GS1900 Series User's Guide
203