Remote Control; Inserting/Changing The Battery; Functionality - Teufel cinebase Technical Description And Operating Instructions

Remote Control

Inserting/Changing the Battery

You should change the battery if the remote control
stops working properly or after 2 years at the latest.
Battery type: Micro/AAA.
To change the battery, remove the battery compart-
ment cover from the remote control, change the
battery and put the cover back in place.
Make sure the polarity is correct!

Functionality

The remote control relays the control signals by
means of infrared light. It is therefore necessary
that you point the front of the remote control in the
direction of the infrared receiver (9) of the Cinebase.
Make sure that the infrared light is not obstructed by
objects.
If the Cinebase receives commands from the remote
control, the power LED (10) will blink rapidly in white.
10
12 • Cinebase
9
WARNING
Swallowing the product battery may result in severe
internal injury or even death.
• Store both new and used batteries so that they
are not accessible to children.
• If it is no longer possible to safely close the
battery compartment, stop using the product and
store it so that it is not accessible for children.
• If you suspect that a battery has been swallowed
or otherwise incorporated, promptly consult a
physician.
Leaking battery acid may lead to chemical burns.
• Do not allow battery acid to come into contact
with skin, eyes or mucus membranes. In the
event of contact with acid, immediately flush the
applicable areas with plenty of clean water and
consult a physician if necessary.
WARNING
Batteries (particularly lithium batteries) can explode
if used improperly.
• Never attempt to recharge batteries.
• Only insert batteries of the same or equivalent
type (micro/AAA).
• You may not heat or short circuit batteries and
storage batteries or dispose of them in fire.
• Do not expose batteries and storage batteries to
direct sunlight.