Software Update; Checking The Version Of The Installed Software; Installing New Software - Teufel cinebase Technical Description And Operating Instructions

Software Update

The Cinebase software is being continually developed.
You can load subsequent versions from our website
www.teufel.de/support/.

Checking the version of the installed software

You will need an empty, fat-formatted USB stick with
at least 2 MB of free space.
1. Turn the Cinebase on.
2. Insert the USB stick in the SERVICE jack (4).
3. Wait for about 2 minutes.
4. Pull out the USB stick.
A text file entitled "CINE_V##.TXT" is located on the
USB stick now; "##" stands for the version number of
the installed software.
The file contains only one line:
"DSP:V##,W58:V##,HDMI:V##,MCU:V##"
In this case as well, "##" stands for the version
numbers of the individual components. However, this
information is only for service purposes.

Installing new software

1. Load the new software from our website.
2. Unpack the downloaded file and save it to the USB
stick.
3. Turn the Cinebase on.
NOTE
Risk of damage!
The Cinebase may not be turned off while the
following steps are being performed!
4. Insert the USB stick in the SERVICE jack (4). The
power LED (10) will start to blink quickly in white.
button (16). The power LED (10) will
5. Push the
blink in different colours during installation.
Finally, the Cinebase will switch to standby (LED
illuminates in red).
6. Pull the USB stick out of the SERVICE jack (4).
The new software is now installed. You can find the
aforementioned text file with the version number for
the installed software on the USB stick.
16 • Cinebase
4
16
10