Table of Contents
Advertisement
Remote control
Pairing of the remote control
By default, the remote control is already paired with
the subwoofer. Should the connection be interrupted
at some point, the pairing process must be repeated.
In such a case, proceed as follows:
1. Turn on the Concept C.
2. Place the remote control at a distance of no more
than 25 cm away from the Concept C.
3. Hold the side button (3) down until the LED ring (2)
starts to blink, and then release it.
– Blinks three time: pairing was successful.
– Blinks ten times: pairing failed and must be
repeated.
Changing the batteries
The remote control uses 2 AAA batteries.
• Simply lift the control dial (1) upwards in order to
open the battery compartment.
• Insert the batteries so that the negative pole
touches the springs.
CAUTION
Leaking battery acid may lead to chemical
burns.
– Do not allow battery acid to come
into contact with skin, eyes or mucus
membranes. In the event of contact with
acid, immediately flush the affected areas
with plenty of clean water and consult a
physician if necessary.
Batteries can explode if not used correctly.
– Never attempt to recharge batteries.
– Only use batteries of the same or
equivalent type.
– Do not heat, short circuit or put batteries
in fire.
– Do not expose batteries to direct sunlight.
1
3
2
• Concept C
1
11
Hide quick links:
Advertisement
Table of Contents
