Using The Pip (Picture-In-Picture) Function (Sh/Vh Series) - BenQ SH Series Installation And Operation Manual

Using the PIP (Picture-In-Picture) function (SH/VH
series)
If the display is connected to either a TV antenna or Video image source, and
also to an active Graphic image source at the same time, you can display both
images on the screen simultaneously by using PIP (Picture-In-Picture) mode.
• PC or DVI must be selected as one of the input sources in PIP mode.
• In PIP mode, some of the remote control functions will be unavailable.
訊號來源 (Input)
1. Press
source (PC or DVI) as the input source.
子母畫面 (Picture In Picture)
2. Press
to PIP mode. Each press cycles the display through the following display
sequence:
Full screen
• To change the input source for the sub picture, press
The sub picture cannot display Component Video (AV1 and AV2) input signals.
• To change the position of the sub picture on the screen, press
the remote control.
• To select audio from the main or sub picture, see
The table below shows the availability of the PIP function under different
Video and Graphic signal input combinations for the Main and Sub pictures.
ATV
DTV
AV1, AV2
AV3
(AV3-S)/
AV4
Sub
(AV4-S)
picture
PC
input
DVI
HDMI
(VH series)
HDMI1,
HDMI2
(SH series)
In the table above:
• ○ : The PIP function is available.
• – : The PIP function is unavailable and cannot be selected.
on the remote control to select a Graphic image
ATV DTV AV1, AV2
－ － －
－ － －
－ － －
－ － －
－ － －
－ － －
－ － －
－ － －
on the remote control to switch display
PIP mode
"PIP Audio" on page
Main picture input
AV3
(AV3-S)/AV4 PC
(AV4-S)
－ ○
－ ○
－ －
－ ○
－ －
－ －
－ －
－ －
Using the remote control
Full screen
訊號來源 (Input)
.
, , + or -
26.
HDMI1,
HDMI
DVI HDMI2
(VH series)
(SH series)
○ －
○ －
－ －
○ －
－ －
－ －
－ －
－ －
on
－
－
－
－
－
－
－
－
11