Table of Contents
Advertisement
Before You Call
Appliance is not level.
Fan noise occurring after the oven is
turned off.
"d-O" is displayed
Cannot move appliance easily.
Appliance must be accessible for
service.
Accela-Heat performs poorly
•
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
•
Be sure floor is level, strong, and stable enough to adequately support range.
•
If floor is sagging or sloping, contact a carpenter to correct the situation.
•
Kitchen cabinet alignment may make oven appear not level. Be sure cabinets are square
and have sufficient room for appliance clearance. Cabinets not square or are built in too
tightly. Contact builder or installer to make appliance accessible.
•
Some models are equipped with a cooling fan that runs during the cooking process to
cool internal electronic components. It is normal for this fan to continue to run for an
extended period of time, even when the oven is off.
•
The door was left open and control set for self-cleaning cycle. Close the door and press
STOP.
•
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
•
Carpet interferes with appliance. Provide sufficient space so appliance can be lifted over
carpet.
•
Gas line is hard-plumbed. Have a flexible CSA International approved metal appliance
connector installed.
•
Accela-Heat not used correctly. This cooking function is intended for convenience, pre-
cooked and other specific foods. See
tices.
"Accela-Heat"
42
on
page 20
and follow best prac-
Hide quick links:
Advertisement
Table of Contents
