Manual Hardware Installation - D-Link DCS-5009L User Manual

Section 2 - Installation
If you prefer to set up your camera without using the Camera Setup Wizard, follow the steps below.
Note: In order to use the mydlink features of this product, you should use either the Camera Setup Wizard or Zero Configuration
Setup. To learn more about mydlink, refer to
Connect the Power Cable and Ethernet Cable
Step 1
Attach the power supply to the power receptor located on the back of the DCS-5009L
and connect it to a wall outlet or surge protector. Power is confirmed when the Power
LED is lit.
Step 2
Connect the included Ethernet cable to the Ethernet port located on the back of the
DCS-5009L. Plug the other end into an available (LAN) port on your router.
Optional: WPS (Wi-Fi Protected Setup)
If your router supports WI-Fi Protected Setup, you may use WPS to connect your
camera to your network wirelessly. For more information, refer to
Setup" on page 18. If your router does not support WPS, you will still be able to set
up your camera's wireless settings using the camera's Web interface. Refer to
Setup" on page 32.
Configure Your Camera
Refer to "Configuration" on page 25
D-Link DCS-5009L User Manual

Manual Hardware Installation

"What is mydlink?" on page
for information on how to configure your camera.
22.
"WPS - Push Button
"Wireless
20