Manual Hardware Installation - D-Link DCS-6045L User Manual

Section 2 - Installation
If you wish to set up your camera without using the Camera Setup Wizard, please follow these steps.
Note: In order to use the mydlink features of this product, you will need to go through the Camera Setup Wizard or Zero
Configuration Setup.
Connect the Camera
Plug in the camera power cord into the DCS-6045L. Move the power switch
to the ON position and wait for the PWR, PLC, and LNK to turn green. If you
have an existing PowerLine adapter, you will need to press and hold the PLC
button on the camera for 5 seconds. After the PLC LED on the camera begins
blinking, press the PLC button on your existing PowerLine adapter within the
next 60 seconds.
Configure Your Camera
Refer to "Configuration" on page 25 for information on how to configure your
camera.
Use PLC to Connect
You can use PLC to connect your camera to your PowerLine adapter. For more
information, refer to "PLC - Push Button Setup" on page 20.
D-Link DCS-6045L User Manual

Manual Hardware Installation

Green
21