• Internet Explorer® 7, Firefox, Safari 4, or Chrome • Installed and enabled Java and ActiveX® controls Network Device and Service • A router (D-Link Cloud Router is recommended) • An Internet connection • An e-mail account (required to create a mydlink account)
Product Overview Front IR LEDs* Light Sensor Camera Lens Microphone PIR Sensor Antenna microSD Speaker Card Slot WPS Status LED Power LED *Note: If you see a white haze when viewing in night vision mode, the IR lights on the camera may be reflecting off a nearby surface.
(both wired and wireless) to your camera, and add it to your mydlink account. If you do not have a D-Link Cloud Router, skip to the Easy Setup section on the next page. Attach the power supply to the...
Easy Setup (All Other Routers) If you do not have a D-Link Cloud Router, you can use any Windows or Mac computer to go through the Setup Wizard, which will guide you through the installation process, from connecting your hardware to configuring your camera Download the Setup Wizard from http://www.mydlink.com/support.
Start mydlink Open a web browser on any computer connected to the Internet. Enter http://www.mydlink.com in the address bar and press Enter. Sign in with your mydlink account registered in the Setup Wizard. • Windows does not have Java installed by default. Download it from http://www.java.com.
Mount the Camera Please refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting. 1. Place the arm mount where you want to position the camera and use a pencil to mark the holes. Make sure you allow adequate space for the necessary cables to be routed.