Toshiba RAS-B10GKVP-E Service Manual page 99

No. Part name
Front panel 4) Press "
1
and remove hooks of the front panel from
the installation plate.
5) Remove the front panel fixing screws.
6) Press the electric parts box with the right
<How to assemble the front panel>
1) Press three center positions and two lower center positions of the air outlet, and
then hang the hanging hooks (4 pcs.) at the top side of the front panel to the rear
plate.
2) Insert the electric dust collector and left and right air filters.
Press in the electric dust collector until the protrusions on both sides are completely
inserted into the holders.
If installation is incomplete, the FILTER indicator (orange) may light.
3) Tighten two screws.
• Incomplete hanging or incomplete pressing may cause a dewdrops or generation
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedures
" part under the front panel
Installation plate
Front panel
Press
(2 pcs.)
thumb while pulling the both sides of the
front panel toward you.
Holder Holder Holder
Protrusion Protrusion Protrusion
of a fluttering sound.
www.heronhill.co.uk
Electric dust Electric dust Electric dust
Electric dust Electric dust Electric dust
collector collector collector
collector collector collector
– 99 –
Remarks
Pull here
Press here
Press here
Holder Holder Holder
Protrusion Protrusion Protrusion
Fax: 01823 665807