Table of Contents
Advertisement
Installing the Base Station
Installing the Backup Batteries on Base Unit
To avoid power outage, you can install (four) AAA batteries (not included in sales) into the
base as the backup.
1. Remove the battery compartment cover (located on the bottom of the base).
. Follow the battery installation display and insert (four) AAA batteries inside the
compartment.
. Put the battery compartment cover back into place.
Connecting the Base Station
1. Choose an area near an electrical outlet and a telephone wall jack (either two RJ11
or one RJ14 type), and place your cordless telephone on a level surface, such as a
desktop or tabletop, or you may mount it on the wall.
. Plug the AC power converter into the
electrical outlet and the DC connector
into the jack on the back of the base.
. Plug one end of a telephone line cord
into the TEL LINE 1 jack on the back
of the base and the other end into the
modular wall jack for Line 1. Plug the
other telephone line cord into the TEL
LINE jack on the back of the base and
the other end into modular wall jack for
Line .
NOTE: If you have only one wall
jack for the both lines, use the TEL
LINE 1/L1 + L2 jack on the back of
base.
4. Place the handset in the base cradle. The charge/in use indicator turns on, verifying the
battery is charging. HANDSET 1 shows in the handset's display after approximately
minutes.
5. Allow the phone to charge for 16 hours prior to first use. If you don't properly charge
the phone, battery performance is compromised.
CAUTION: To reduce risk of personal injury, fire, or damage use only
the 5-2760 power adaptor listed in the user's guide. This power
adaptor is intended to be correctly orientated in a vertical or floor
mount position.
1
Advertisement
Table of Contents
