Skier's Choice Supra Instruction Manual page 59

Hide thumbs Also See for Supra:
Table of Contents

Advertisement

Your Supra boat cover is made from the finest canvas and
webbing to ensure that your boat will be protected in the off
season. The cover has been designed to fit securely around
each boat.
Use the following procedure when covering the boat:
1.
Be sure that the cover fits snugly at the bow then unfold
from front to back.
2.
Be sure to install cover pole(s) and adjust to proper height,
using set screw on pole(s). This will keep water from
gathering in the center, which can damage the cover.
3.
Secure all fastening straps around the trailer frame.
4.
Pull the draw cord equally from both sides and tie off to the
lifting eyes on the stern in accordance with the illustration.
Folding Cover
When folding the cover for storage, be sure the cover is dry. Take
care not to scratch the canvas finish against rough surfaces.
Store in a dry location.
Cover Repair
If the cover becomes damaged, immediately patch and reseal
the area. Use a tent seam sealer to reseal any new stitches.
Spray fabric guard on scraped or worn surfaces. Canvas tears
should be repaired professionally and stitches sealed to prevent
leakage.
DO NOT trailer the boat with the mooring cover installed.
This type of damage IS NOT covered by your boat
warranty!
© 2008 Skier's Choice, Inc.
Mooring Cover
Optional Tonneau Cover
The optional tonneau cover is designed to snap over the bow
of the boat. Its purpose is to minimize air flow into the cockpit
area when the boat is in use and as a storage cover when used
in combination with the optional cockpit cover.
DO NOT trailer the boat with the tonneau cover installed.
The tonneau cover is not designed as a trailer cover and
may come unsnapped or rip. This type of damage IS NOT
covered by your boat warranty!
Optional Cockpit Cover
The optional cockpit cover is a snap down storage cover
designed to help protect the interior of your boat. To install the
cover, start at the windshield and work towards the transom. Be
sure to install the cover poles to prevent water pocketing.
DO NOT trailer the boat with the cockpit cover installed.
The cockpit cover is not designed as a trailer cover and may
come unsnapped or rip. This type of damage IS NOT covered
by your boat warranty!
 —

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents