Replacement Parts - Powermatic PM1000 RU Operating Instructions And Parts Manual

Symptom
Excessive vibration.
Blade not square with
miter slot, or fence not
square to blade.
Blade does not reach 90
degrees.
Cuts out-of-square when
crosscutting.
Cuts not true at 90 or 45
degrees.
Tilting or raising
handwheel difficult to
turn.

15.0 Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-
800-274-6848 Monday through Friday (see our website for business hours, www.
Model Number and Serial Number of your machine available when you call will allow us to serve you quickly
and accurately.
Probable Cause
Tilting or raising lock knobs not
tightened.
Machine not resting evenly on floor.
Blade out of balance.
Pulley loose.
Belt is worn, cracked or frayed.
Motor not functioning properly.
Blade is warped.
Table top not parallel to blade.
Fence not parallel to blade.
90 degree stop is out of adjustment.
Pointer bracket is hitting before the
blade reaches 90 degrees.
Miter gauge out of adjustment.
Miter slot misaligned.
Stop screws not set properly.
Lock knob not released.
Worm and trunnion segment caked
with sawdust and pitch.
Worm and trunnion segment out of
alignment.
Remedy
Tighten lock knobs on handwheels
Make sure floor is level; use shims beneath
cabinet if needed.
Replace blade.
Check motor pulley and spindle pulley.
Tighten set screws if needed.
Replace belt.
Have motor
inspector. Repair or replace.
Replace saw blade.
Adjust table parallel to blade.
Adjust fence parallel to blade.
Adjust 90 degree stop.
File down the right side of pointer bracket
until blade can reach 90 degrees.
Re-set stops and pointer on gauge.
Realign table to blade.
Readjust screws.
Loosen lock knob.
Clean and re-grease worm and segment.
Realign worm with segment.
29
checked by a qualified
powermatic .com). Having the