Table of Contents
Advertisement
7.0 Setup and assembly
7.1 Shipping contents
7.1.1 Carton contents (Figure 1)
1
Cabinet saw
1
CE Type Guard assembly (A) (not shown)
1
Miter gauge (B)
1
CE Riving knife (D)
1
Arbor wrench (E)
2
Storage hooks (F)
1
Push stick (G)
2
Knobs (H)
2
Handles (I)
2
Hand-wheels (J)
1
Motor Cover (K)
Extension wing – Left (L)
1
Extension wing – Right (M)
1
Insert plate – (N)
1
1
Dado Insert (not shown)
1
Blade (not shown)
Low profile riving knife – (P)
1
1
Hardware package
1
Two Way Dust Chute (not shown)
1
Operating Instructions and Parts Manual
Figure 1
7.1.2 Hardware package (Figure 2)
6
Hex cap screws, M10x35 (HP-1)
6
Lock washers, M10 (HP-2)
6
Flat washers, M10 (HP-3)
4
Socket head button screws, M6x16 (HP-4)
4
Lock washers, M6 (HP-5)
4
Flat washers, M6 (HP-6)
3
Socket flat head screws, M6x10 (HP-7)
Figure 2
Note: Fence and rail assemblies, and wood
extension tables and legs, are shipped in separate
cartons.
Read
assembly
instructions
assembly. The saw must be disconnected
(unplug!) from power during assembly. Failure
to comply may cause serious injury.
7.2 Tools required for assembly
Hex keys – 3 and 4mm
Open end wrenches – 14 and 17mm
Cross point screwdriver
Straight edge
Rubber mallet (or hammer with block of wood)
Note: A ratchet wrench/socket set may speed
assembly time. Additional tools may be needed for
assembly of fence and rails – consult Accu-Fence
manual.
7.3 Unpacking and cleanup
Remove all contents from shipping carton. Remove
items from inside cabinet. Do not discard carton or
packing material until saw is assembled and
running satisfactorily.
Compare contents of your container with above
parts lists to make sure all parts are intact. Missing
parts, if any, should be reported to your distributor.
(Check saw first in case parts were preinstalled.)
Read instruction manual thoroughly for assembly,
maintenance and safety instructions.
10
and
understand
all
before
attempting
Hide quick links:
Advertisement
Table of Contents
