Table of Contents
Advertisement
7.0 Setup and Assembly
7.1 Shipping Contents
7.1.1 Carton Contents (Figure 1)
1
Cabinet saw
1
Guard assembly (A)
1
Miter gauge (B)
1
Anti-kickback pawl assembly (C)
1
Riving knife (D)
1
Arbor wrench (E)
2
Storage hooks (F)
1
Push stick (G)
2
Knobs (H)
2
Handles (I)
2
Handwheels (J)
1
Motor Cover (K)
1
Extension wing – Left (L)
1
Extension wing – Right (M)
1
Insert plate – (N)
1
Low profile riving knife – (P)
1
Hardware package
1
Warranty card
1
Operating Instructions and Parts Manual
Figure 1
7.1.2 Hardware Package (Figure 2)
6
Hex cap screws, M10x35 (HP-1)
6
Lock washers, M10 (HP-2)
6
Flat washers, M10 (HP-3)
4
Socket head button screws, M6x16 (HP-4)
4
Lock washers, M6 (HP-5)
4
Flat washers, M6 (HP-6)
3
Socket flat head screws, M6x10 (HP-7)
Figure 2: hardware package p/n PM1000-HP
Note: Fence and rail assemblies, and wood
extension tables and legs, are shipped in separate
cartons.
assembly
instructions
assembly. The saw must be disconnected
(unplug!) from power during assembly. Failure
to comply may cause serious injury.
7.2 Tools Required for Assembly
Hex keys – 3 and 4mm
Open end wrenches – 14 and 17mm
Cross point screwdriver
Straight edge
Rubber mallet (or hammer with block of wood)
Note: A ratchet wrench/socket set may speed
assembly time. Additional tools may be needed for
assembly of fence and rails – consult Accu-Fence
manual.
7.3 Unpacking and Cleanup
industrial-grade low-friction corrosion-resistant
coating on the table and table extensions.
While the coating is durable, it can be damaged
if metal or other hard and/or sharp objects
strike,
gouge,
Significant damage to the coating may affect its
performance. Use care when unpacking and
locating the machine.
Remove all contents from shipping carton. Remove
items from inside cabinet. Do not discard carton or
packing material until saw is assembled and
running satisfactorily.
10
Read and understand all
before
attempting
Model
PM1000T
has
or
scratch
the
surface.
an
Advertisement
Table of Contents
