Memory Problems - MAXDATA Performance 120T User Manual

n
n
n
n
n

Memory Problems

The POST does not show an increased memory capac-
ity when you have already installed additional memory -
n
n
n
The O/S issues an insufficient memory error message
during operation -
n
n
n
Windows NT 4.0 does not support infrared devices.
Remove any objects that sit between the communicating
path.
Make sure the communicating devices are not more than 1
meter apart and are aligned in a straight-line fashion.
Make sure that IR device is enabled in the Control Panel. If
the infrared icon at the lower right corner of the task bar has
a red ‘x symbol, it is being disabled. Click on the icon and in
the Option page check off the Infrared Communication item.
Check the infrared setting in BIOS Setup utility. Go to
Section 2 BIOS Setup to find out how this is done. If you are
using Windows 95 and have enabled Fast IR option in the
BIOS Setup, you must load the vendor-specific IR driver
manually for it to work (Windows 95 comes with standard
IrDA driver only.)
Certain brands of memory module may not be compatible
with your system. You should ask your vendor for a list of
compatible makers of the DIMM.
The memory module may not be installed properly. Go back
to Section 4 Upgrating Your Notebook to review the details
of this operation.
The memory module may be defective.
This is often a software or Windows-related problem.
Close the application programs you’re not using and restart
the system.
Otherwise, you have to install additional memory module.
For instructions, go to Section 4 Upgrading Your Notebook.
Section 5 TROUBLE SHOOTING
5-11