Table of Contents
Advertisement
-
If you are using the standard DMX-controllers, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter cables.
-
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture.
Always connect output with the input of the next fixture until all fixtures are connected.
-
If you use a controller with 5 pins DMX connector, you need to use a 5 to 3 pins adopter
-
At last fixture, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm 1/4W resistor
between pin 2(DMX-) and pin 3(DMX+) into a 3 pins XLR-plug and plug it in the DMX-output of the last
fixture.
-
Connect the fixture together in a daisy chain by XLR plug cable from the output of the fixture to the input
of the next fixture. The cable cannot be branched or split to a Y cable. DMX 512 is a very high speed
signal. Inadequate or damaged cables, soldered joints or corroded connectors can easily distort the
signal and shut down the system.
-
The DXM output and input connectors are pass-through to maintain the DMX circuit, when power is
disconnected to the unit.
-
Each fixture needs to have a DMX address to receive the data from the controller. The DMX address
number which could be read from rear panel of each fixture is between 000~511.
-
The end of the DMX 512 chain should be terminated to reduce signal errors.
Proper Laser Set Up & Usage
6.
This fixture has been designed to be hung. It is recommended for safety purposes, your lighting effect are
properly mounted using a suitable hanging clamp and safety cable. Items appropriate for safe and effective
mounting are easily sourced from your lighting vendor. International laser safety regulations require that lasers
must be operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation
between the floor and the lowest laser light vertically. Additionally, 2.5 meters of horizontal separation is required
between laser light and audience or other public spaces.
11 / 22
Advertisement
Table of Contents
