Tools - Hoover Power Path Owner's Manual

CONNECTHOSEFORTOOLUSE
Howto Attach
4.1 Open Accessory Hose Suction Port (A).
Insert hose end, aligning the indicator with the
unlock arrows.
Rotate clockwise to lock position (B).
4.2 Hold open the Accessory Hose Solution Port
door (C).
Plug Accessory Hose Solution Tube connector
by inserting firmly into Hose Solution Port (C)
and rotating clockwise to lock position.
How to Remove
4.3 Disconnect Accessory Hose Solution Tube
Connector from Accessory Hose Solution Port
by rotating counter-clockwise and pulling upward. Do
not pull on tube, this may cause damage. Accessory
port door will automatically close.
Rotate accessory Hose end counterclockwise
from the locked position to the unlocked
position and remove by pulling out.
Snap Accessory Hose Suction Port door back
into place. Make sure to snap firmly to
ensure proper suction, unit may lose suction if
not closed properly.
W
TOOLS
(*Availableon select models only.)
A. Stair Tool*: 6 inches wide, 2 built4n rows of brushes to
help providethe scrubbing action that some spots may need for
removal on yourcarpeted stairs.
B. Upholstery Tool has a built-in brush to help provide the
scrubbing action some spots may need for removal.
NOTE: Toolslocated and stored in Mesh Storage Bag.
Howto Attach Tools
4.4 To ensure maximum performance and to protect your carpet,
be sure to place the handle in the upright position while using
the accessory hose. Placing handle in the upright position
shuts off the brushes.
NOTE:All tools attach to the hose in the same manner:
4.5 Connect tool to hose by sliding it onto connector until the
tab locks it securely (E).
Using your thumb, push forward and up on the latch to
remove tool (F).