Hoover Power Path Owner's Manual page 7

REMOVEAND REPLACECLEAN
WATERSOLUTIONTANK
3.1 Press Clean Water Solution Tank latch (A). Tilt Clean
Water Solution Tank away from cleaner and remove.
3.2 Unscrew measuring cap from the top of Clean Water
Solution Tank (B).
3.3 Fill CleanWater Solution Tank with hot tap water.
3.4 Fill measuring cap with cleaning solution 2 times,
(approximately 2 oz.). Pour into solution tank and replace
measuring cap.
3.5 Insert clean water solution tank on an angle to attach to
unit.
NOTE: Using more than the recommended amount of
cleaning solution may cause excessive foaming.
E
CARPETCLEANING
3.6 Plug cord into electrical outlet. Step on handle release
pedal, to put unit in cleaning position.
3.7 Turn power switch to the "ON" position.
3.8 Squeeze trigger (C)to apply cleaning solution and slowly
push cleaner forward (equals one wet stroke). Continue to
squeeze trigger and slowly pull cleaner back toward you
(second wet stroke).
3.9 Release trigger and slowly push cleaner forward over
area just sprayed with solution (dry stroke). Then slowly pull
cleaner back toward you without squeezing trigger (dry
stroke). Continue using dry strokes until little water is visible
passing through the nozzle (Pass over the same area a
minimum of 4 times = 2 while squeezing the trigger and 2
without).
NOTE: For best results, use straight, parallel strokes.
Overlap strokes by 1 inch to help prevent streaking.