Table of Contents
Advertisement
Getting started
Handset lifter installation
On
ON/OFF
button
LIFTER AUDIO ADJUST
Adjust lifter audio
1. Make sure that the LIFTER MODE light
on the headset base is on. Press the
MODE button on the headset base to
change the mode.
MODE
2. Put the headset next to your ear.
(AT&T model TL7610/TL7611/TL7650/
TL7651).
3. Press ON
listen for the dialing tone. If there is no
dialing tone or buzzing noise, slide the
LIFTER AUDIO ADJUST on the side of
the headset base from A to G until the
dialing tone is clear.
4. If the dial tone is not clear, repeat step
3 above until you find the clearest dial
tone.
on the headset and
/OFF
10
Advertisement
Table of Contents
