Using The Auto-Equalizer - Pioneer AVH-P5750DVD Operation Manual

Section
15 Digital Signal Processor
! The center speaker largely determines the
sound image and getting the balance right
isnt easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Touch NEXT twice on the DSP function
menu.
2 Touch PARA EQ.
3 Touch a or b to select the desired item.
Each time you touch a or b selects the item
in the following order:
SP-SEL (speakers)BAND (bands)
FREQUENCY (center frequency)LEVEL
(equalizer level)Q. FACTOR (Q factor)
4 Touch c or d to select the speaker to
be adjusted.
Touch c or d until the desired speaker ap-
pears in the display.
REAR (rear speakers)CENTER (center speak-
er)FRONT (front speakers)
# You cannot select speakers whose size is set
at OFF.
5 Touch b and then touch c or d to se-
lect the equalizer band to be adjusted.
Each time you touch c or d selects equalizer
bands in the following order:
LOW (low)MID (mid)HIGH (high)
6 Touch b and then touch c or d to se-
lect the center frequency of selected band.
Touch c or d until the desired frequency ap-
pears in the display.
40Hz50Hz63Hz80Hz100Hz125Hz
160Hz200Hz250Hz315Hz400Hz
500Hz630Hz800Hz1kHz1.25kHz
76
En
1.6kHz2kHz2.5kHz3.15kHz4kHz
5kHz6.3kHz8kHz10kHz12.5kHz
7 Touch b and then touch c or d to ad-
just the equalizer level.
Each time you touch c or d increases or de-
creases the equalizer level. +06  06 is dis-
played as the level is increased or decreased.
8 Touch b and then touch c or d to se-
lect the desired Q factor.
Each time you touch c or d switches between
the following Q factor:
NARROW (narrow)WIDE (wide)
# You can adjust parameters for each band of
the other speakers in the same way.
Note
You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on the next page).
You can turn the auto-equalizer on or off.
1 Touch NEXT twice on the DSP function
menu.
2 Touch AUTO EQ.
# You cannot use this function if auto TA and
EQ has not been carried out.
3 Touch a to turn the auto-equalizer on.
# To turn auto-equalizer off, touch b.