Setting The Speaker Setting - Pioneer AVH-P5750DVD Operation Manual

Av receiver/dvd player with 6.5 inch wide display
Hide thumbs Also See for AVH-P5750DVD:
Table of Contents

Advertisement

Digital Signal Processor
Adjusting the Music mode
You can adjust the Music mode with the fol-
lowing three controls.
! Panorama (PANORAMA) extends the front
stereo image to include the surround
speakers for an exciting wraparound ef-
fect.
! Dimension (DIMENSION) allows you to
gradually adjust the sound field either to-
wards the front or the rear.
! Center Width Control (CENTER WDT) al-
lows center-channel sounds to be posi-
tioned between the center speaker and the
left/right speakers. It improves the left-cen-
ter-right stage presentation for both the dri-
ver and the front passenger.
1
Touch NEXT on the DSP function menu.
2
Touch DOLBY PL II.
3
Touch MUSIC and then touch ADJUST.
# You can operate ADJUST only when MUSIC
has been selected.
4
Touch a or b to select PANORAMA (pa-
norama).
Each time you touch a or b selects the item
in the following order:
PANORAMA (panorama)DIMENSION (di-
mension)CENTER WDT (center width)
5
Touch c to turn the panorama control
on.
# To turn the panorama control off, touch d.
6
Touch b and then touch c or d to ad-
just front/surround speaker balance.
Each time you touch c or d it moves the
sound towards the front or the surrounds.
+3  3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
7
Touch b and then touch c or d to ad-
just the center image.
Each time you touch c or d it gradually
spreads the center channel sound into the
front left and right speakers over a range 07.
3 is the default and its recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.

Setting the speaker setting

You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select SMALL (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1
Touch NEXT on the DSP function menu.
2
Touch SP SET.
3
Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)PHASE (sub-
woofer setting)
# You can switch to PHASE only when the sub-
woofer has been set to ON.
Section
15
71
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents