Activating And Deactivating; Automatic Shutdown; Use; Tabletop Remote Control - Teufel Concept C 200 Black Edition Technical Description And Operating Instructions

Use

Activating and deactivating

8
• Using the mains switch 8, you can activate or deacti-
vate your Concept C 200.
In standby mode and LED 1 is red.
• With the button 1 "Standby" or 14 "Power", you
can switch your Concept C 200 to operating and/or
standby mode.
In operating mode, the LED 1 is blue.

Automatic shutdown

If there is no audio signal for 20 minutes, the subwoofer
switches to standby automatically. The subwoofer acti-
vates as soon as an audio signal is present on the RCA
jacks 4 "LINE IN"
10
• Concept C 200

Tabletop remote control

13 "Bass": You can use this rotary encoder to control the
bass reproduction of your subwoofer.
LED A indicates a lower bass level, whereas LED B
indicates a higher bass level.
14 "Power": Use this button to switch the Concept C 200 on
or to Standby mode.
1
15 "Volume": Use this rotary encoder to set the volume of
the Concept C 200.
LED C shows the relative volume. Any separate volume
settings at the source device (PC, Mac, CD player, etc.)
are not considered here.
16 "PHONES": You can connect earphones here using a
3.5 mm phone jack. The subwoofer and satellite speakers
are then automatically switched to mute.
17 "MIC": You can connect a microphone here using a
3.5 mm phone jack. The microphone is automatically
recognised by the computer. You may receive the notifica-
tion that a recording device has been connected.
Note: The microphone works only if you have connected
A
B
C
the Concept C 200 via USB to your computer.
13
14
15
16
17