Table of Contents
Advertisement
DSP-40
3. Transmission, save, print image through MODEM
1) Preparation of transmission
① Construct network referring to page 8 in this manual, and execute "DVRDIALUP.EXE".
② Referring to previous "1. Set up "DVR DIALUP", set up "DEVICE" and "BAUD RATE". In the
status bar, message "online" is displayed.
③ If MODEM is initialized successfully, the name of MODEM is displayed in the status bar.
④ Clicking "Connect", sub menu of "Connect" menu, the name and status of remote are
displayed. Remote name is set up in "Phonebook", sub menu of "Setup" menu. Refer to previous
"1. Set up host program".
⑤ Clicking "Connect", connection trial starts. And clicking "Disconnect", connection trial fails.
⑥ In the middle of connecting, clicking "Disconnect", sub menu of "Connect" menu, connection
ends.
2) Transmission, save, and print bypass image
This is the same as using serial network. Refer to page 48 of this manual.
50
Advertisement
Table of Contents
