(5)
Remove the Cover sensor actuator from the Ink head base unit.
Cover sensor actuator
Cover sensor
actuator spring
4.4
Ink Head Base unit, Print Head
Note:
After replacing Print head, adjustment is need by using the Service
software tool.
<Disassembly>
(1)
Remove the screw securing the Waste ink needle. (It is fitted nearest to the
removed Head PCB ASSY position.) Release the Waste ink tube from the three
hooks.
Note:
Use caution when handling the Waste ink needle; it may cause you injury.
Fig. 3.9
Screw, bind B 2X6
Waste ink needle
Fig. 3.10
III-9
Ink head base unit