Maintenance Checklist - Powermatic 15S Owner's Manual

[ ] Work area around machine marked off clearly.
[ ] Non-skid floor strips in area where operator normally stands.
[ ] Inspect entire machine for loose bolts, nuts, screws. Tighten and replace as necessary.
[ ] Clean table and cutterhead area, removing sawdust and chips with a soft bristle brush. Remove gum and
pitch with oven cleaner.
[ ] Lubricate appropriate places with a good grade non-hardening grease.
[ ] Clean table surface. If rusted, use paste mixture of household ammonia, a good commercial
detergent and 000 steel wool. Wash surface down with hot, soapy water, rinse and dry thoroughly.
Coat surface with talcum powder, rubbing briskly into surface with a clean blackboard eraser.
[ ] Check blade condition; should be sharp and free of nicks or grooves.
[ ] Check belt condition. Replace as needed. Dress with belt dressing. Check belt tension.
[ ] Check motor for loose wiring and sawdust congestion, pulleys tight and in line.
[ ] Check bearings. Replace any bad or suspect bearings immediately.
[ ] Check leveling of extension tables with main table.

Maintenance Checklist

for Model 15S Planer
45