Table Rollers - Powermatic 15S Owner's Manual

TABLE ROLLERS

Your planer is supplied with two table rollers (Fig.
14) which turn as the stock is fed into the
machine, thus reducing friction. It is not possible
to give exact dimensions on the proper height
setting of the table rollers because each type of
wood behaves differently. As a general rule,
however, when planing rough stock the table
rollers should be set at high position. When
planing smooth stock the rollers should be set at
low position.
NOTE: When raising the roller higher above the
table, the range is from zero to 0.06" (Fig. 15).
The table rollers are factory set for average
planing and are parallel to the table surface. If
you desire to adjust the table rollers higher or
lower, proceed as follows:
1. Disconnect machine from power source.
2. Lay a straight edge across both rollers.
3. On one side of the table, loosen the set
screws (Fig. 16) with a 3mm hex wrench,
and turn the eccentric shafts to raise or lower
the rollers.
4. When proper height is achieved, tighten set
screws.
5. Adjust the rollers from the opposite side of
the table in the same manner.
IMPORTANT: Be sure that the height of front and
rear rollers are the same. And the table rollers
must always be set parallel to the table.
14