Maintenance; Lubrication - Powermatic 15S Owner's Manual

MAINTENANCE

WARNING: Disconnect machine from
!
power source before performing any
maintenance.
Periodic or regular inspections are required to
ensure that the machine is in proper adjustment,
that all screws are tight, that belts are in good
condition and properly tensioned, that dust has not
accumulated in the electrical enclosures, and that
there are no worn or loose electrical connections.
Buildup of sawdust and other debris can cause
your machine to plane inaccurately. Periodic
cleaning is not only recommended but mandatory
for accurate planing.
Close-fitting parts, such as the cutterhead slot and
gibs, should be cleaned with a cloth or brush and
non-flammable solvent, and freed from clinging
foreign matter.
Remove resin and other accumulations from feed
rollers and table with a soft rag and non-flammable
solvent.
Periodically check all the chains for proper tension
and adjust accordingly if needed.
The item numbers on this chart are referenced with the illustrations below.
No. Position
1 Drive Chain
2 Gear Box
3 Return Rollers
4 Worm Gear
5 Lead Screw
6 Column
7 Table Chain
8 Feed Rollers
22
Interval
Inspect an lubricate monthly
When operated more than
2,500 hours
Inspect frequently
Inspect and lubricate monthly
Inspect and lubricate monthly
Inspect and lubricate weekly
Inspect monthly, lubricate
when needed
Inspect and lubricate daily
before startup
The table should be kept clean and free of rust.
Some users prefer a paste wax on exposed steel
and cast iron surfaces. The wax provides a layer of
protection as well as reducing friction between
lumber and the table, making cuts faster and
smoother. Avoid any wax that contains silicone or
other synthetic ingredients. These materials can
find their way into lumber and can make staining
and finishing difficult.
Another option is talcum powder applied with a
blackboard eraser rubbed in vigorously once a
week; this will fill casting pores and form a
moisture barrier. This method provides a table top
that is slick and allows rust rings to be easily wiped
from the surface. Important also is the fact that
talcum powder will not stain wood or mar finishes
as wax pickup does.

LUBRICATION

The bearings on the cutterhead are factory
lubricated and sealed for life – they require no
further lubrication.
Suitable Types of Lubricant
Grease
HD-100, Mobil Gear 627, Shell Omala 100,
ESSO Spartan EP-100
SAE-30
Grease
Grease
Clean columns and apply SAE-30
Grease, or good quality bicycle chain lubricant
SAE-30
Fig. 33
Fig. No.
34
34
35
36
36
36
37
38