Steering Trim - GM-Racing Leopard 90505 Instruction Manual

Operating the RC
• Take Your Truggy Leopard 4WD 1/8 never with low transmitter or receiver batteries.
• Let the ON / OFF switch never look at the trip, otherwise, the batteries do not last long.
• Turn the Transmitter always on first, and then the car.
• After driving the first ever recipient and then the transmitter off.
• For optimal use must enter both the steering and the Throttle Trim set:

Steering Trim

The vehicle must also without activating the wheel straight run. If not, then turn the Trimbutton
over the steering wheel in the direction that is necessary to move the carrier to go straight.
Throttle/Brake Trim
Let the pistoldeduction in neutral position and push the vehicle on the ground a little. It must be
easy to roll. Now press the brake, the vehicle should stop immediately. Does it not, turn on Trim right
of the steering wheel, the throttle precisely
Carburetor Basic Settings
Check before starting the engine first the carburetor linkage.
Then remove the airfilter and control the gas of the carburetor.
To turn on the transmitter and model and review the apparent gap.
It should be between 1 and are 1.5mm (see figure).
Enter now full and check whether the carburetor completely open.
Checklist
• Check all screws on permanent seat
• Check whether all the moving parts work without errors.
• Check the air filter. Where appropriate, clean it and oil it with a new Air filter Oil - Take oil never
without air filter!
• Check the Fuel tubes for leaks.
• Check the batteries in the remote control.
• Check your frequency, so that a trouble-free operation is ensured.
14 GM-Racing Leopard
Have to be Full opened!
Throttle
90505 & 90505.RTR