Sharp MX-M264N Operation Manual page 766

Problem
Two-sided copying
does not take place.
The paper size of a
tray cannot be set.
Point to check
Does the paper type setting of the
selected tray specify a type of paper that
cannot be used for two-sided copying?
Are you using a special size or type of
paper?
Are you copying using settings that do
not allow two-sided copying?
Have functions been disabled by the
administrator?
Have functions been disabled by the
administrator?
Check "Tray Settings" in the system settings. If the
[Disable Duplex] checkbox is selected
copying using that tray will not be possible. Change the
paper type setting to a type that can be used for
two-sided printing.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change"
For the paper types and sizes that can be used for
two-sided copying, see "SPECIFICATIONS" in the Start
Guide.
Two-sided copying can generally be combined with
other special modes, however, some combinations are
not possible. If a prohibited combination is selected, a
message will appear in the touch panel.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
8-15
TROUBLESHOOTING
Solution
, two-sided
Contents