USER CONTROL 1/2, 2/2 Menu
The USER CONTROL 1/2, 2/2 menu is used for
adjusting the picture.
Items that cannot be adjusted depending on the input
signal are displayed in blue.
Adjusts color intensity (CHROMA) and tones
AUTO ADJ VALUE
Selects ON or OFF of the Auto adjustment. When set
to OFF, this parameter is reset to the factory setting.
When set to ON the automatically adjusted value is
Display the color bar signals (Full/SMPTE/EIA/HD)
on the screen and press ENTER. The AUTO
ADJUSTMENT screen starts. Exit from the AUTO
ADJUSTMENT screen using the MENU button after
finishing adjustment. When the adjustment is done
correctly, the AUTO ADJ VALUE is automatically
If you have selected the full color bars, enter eight
Saves the current VOLUME, CONTRAST, PHASE,
CHROMA or BRIGHT settings on the control panels.
You can select MEMORY1 or MEMORY2 area to
save the data.
Loads the VOLUME, CONTRAST, PHASE,
CHROMA or BRIGHT setting of the control panels
from the setting saved in a memory described above. If
you select Standard, the settings are reset to the
You can finely adjust the adjustment range of buttons
on the right-side of the front panel; CONTRAST,
PHASE, CHROMA and BRIGHT buttons.
Adjusts the picture contrast. You can adjust the
contrast from 0 to 100.
Adjusts the picture brightness. You can adjust the
brightness from –50 to +50.
Adjusts color intensity. The higher the setting, the
greater the intensity.
The lower the setting, the lower the intensity. You can
adjust the color intensity from 0 to 100.
Adjusts color tones. The higher the setting, the
complexion becomes greenish.
The lower the setting, the picture becomes purplish.
You can adjust the color tones from –50 to +50.
Adjusts the picture sharpness. The higher the setting,
the sharper the picture. You can adjust the color
sharpness from OFF to 100.