Install Part
Methods
After wrapped pipe and wire, pull them though the pipe hole (as shown in fig.5).
Hang the mounting slot behind indoor unit on the pothook of the rear panel and move
it to check if it is firm enough (as shown in fig.6).
Ensure the install height of indoor unit is 2m or higher.
Right pipe
Install the outdoor unit
Install connection pipe
Align the flare of connection pipe to the joint flare of relative valve.
Tighten the nuts on connection pipe forcibly then tighten it by spanner as shown in fig.7.
Note: Too great of torque would damage nuts.
are recommended piping ways.
Rear right pipe
Coonection pipe
Power connect wire
Tailings
Tailings
Fig.4
Wrapping strap
Drainage hose
Fig.5
Fig.6
Left pipe
Rear left pipe
Signal control wire