Audionet SAM G2 User Manual page 29

For Audionet Metal Remote Control RC 2 the DIP switch for selecting
the system address is located here:
Put the DIP switch labelled 'SYS ADDRESS' in position '19' or '16' ac-
cording to the following table:
Audionet preamplifier
PRE G2, PRE 1 G3,
DNA, DNP, DNA 1
Note
·
If not ordered explicitly, the Audionet Metal Remote Control is pre-
configured to setting '19' of the DIP switch.
·
Older models of Audionet preamplifiers use system address 16.
·
Audionet Metal Remote Control RC 2 uses both slider switches of the
DIP switch. The one for configuring the preamplifier is the upper one
with the left side labelled '19' and the right side labelled '16'.
DIP switch for system address on RC 2
(the upper slider is for configuring a preamplifier)
SAM G2,
MAP 1
29
Address
19
16