Disposal; Troubleshooting - Hilti TE 2 Operating Instructions Manual

This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement as
a result of normal wear and tear are not covered by this
warranty.
en
Additional claims are excluded, unless stringent nation-
al rules prohibit such exclusion. In particular, Hilti is
not obligated for direct, indirect, incidental or conse-
quential damages, losses or expenses in connection
with, or by reason of, the use of, or inability to use the
tool for any purpose. Implied warranties of mer-
chantability or fitness for a particular purpose are
specifically excluded.

Disposal

Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti sales repre-
sentative for further information.

Troubleshooting

Symptom
The tool doesn't start
No hammering action
Tool doesn't produce full
power
Drill bit cannot be released
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5070802 / 000 / 00
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
Possible cause
Fault in the electric power supply
Defective supply cord or plug
Switch defective
The tool is too cold
Function selection switch
set to rotary drilling
Cross-section of the
extension cord is inadequate
Control switch is not pressed fully
Function selection switch set
to precision hammering action
Forwards / reverse switch set
to reserve when drilling
Chuck not opened fully
Possible solution
Plug in another electric tool and check
whether it starts
Have it checked by an electrical
specialist and replace if necessary
Have it checked by an electrical
specialist and replace if necessary
Allow tool to reach the minimum
operating temperature
See section "Before use"
Set function selection switch
to hammer drilling
Use an extension cord of adequate cross-
sectional area. See section "Before use"
Press the control switch as far as it will go
Set function selection switch
to hammer drilling
Set forwards / reverse switch
to forwards
Pull the chuck locking sleeve back as
far as it will go and remove the insert
tool