Assembly - Hilti TE 2 Operating Instructions Manual

Variable speed switch
Rotary-only drilling mode
Gearing and hammering mechanism with permanent
grease lubrication
Pivotable side handle (360°)
Mechanical depth gauge
The tool is designed for the following uses:
Use
TE 2 / TE 2-S / TE 2-M:
Hammer drilling in concrete,
masonry and natural stone
TE 2-S:
Drilling with precision
hammering action in perforated – TE-C hammer drill bits
brick, tiles and marble
TE 2 / TE 2-S:
Drilling in wood, drywall panels Quick-release chuck
and metal
TE 2-M:
Drilling in wood, drywall panels, Interchangeable quick-release chuck
tiles and metal

Assembly

It is essential that the safety precautions printed in these
operating instructions are read and observed.
Fitting the side handle
1.Unplug the tool from the mains socket.
2. Release the side handle clamping band by turning
the handle in a counter-clockwise direction.
3. Fit the side handle clamping band over the chuck
and onto the cylindrical section at the front end of
the tool.
4. Pivot the side handle into the desired position.
5. Tighten the side handle securely to prevent inad-
vertent movement.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070802 / 000 / 00
Required insert tools
Drill bits with TE-C connection end Drilling in concrete:
– Short hammer drillbits
– Long hamer drill bits
Drill bits with TE-C connection end Drilling in brittle materials:
– Thin-barrel core bits
with TE-C adaptor
for insert tools
with cylindrical shank or hexagonal shank
for rotary-only drilling
Wood drill bits
Metal drill bits
Hole saws
for insert tools
with cylindrical shank or hexagonal
shank for rotary-only drilling:
Wood drill bits
Metal/stepped drill bits
Hole saws
Interface for quick-release chuck (TE 2-M)
Precision hammering action (TE 2-S)
High spindle speed without hammering action (TE 2-M)
Lockbutton for sustained operation
Right of technical changes reserved
Diameter range
Anchor holes of 4–22 mm (
Through holes of 4–22 mm (
Anchor holes of
Cutting sockels of 25–68 mm (1"–2
4–20 mm ( 3 /
16
3–13 mm ( 3 /
16
25–68 mm (1"–2
4–10 mm ( 3 /
16
10–20 mm ( 3 /
8
3– 8 mm ( 3 /
16
8–13 mm ( 5 /
16
25–68 mm (1"–2
Check that the side handle is seated securely.
The supply voltage must correspond to the information
on the type plate.
If extension cords are used: Only extension cords of a
type approved for the intended use and of adequate cross
section may be used. Failure to observe this point may
"– ") dia.
3 / 7 /
16 8
"– ") dia.
3 / 7 /
16 8
"– ") dia.
4–22 mm ( 3 / 7 /
16 8
") dia.
5 /
8
"– ") dia.
3 /
4
"– ") dia.
1 /
2
") dia.
5 /
8
"– ") dia. in 2nd gear
3 /
8
"– ") dia. in 1st gear
3 /
4
"– ") dia. in 2nd gear
5 /
16
"– ") dia. in 1st gear
1 /
2
") dia. in 1st gear
5 /
8
en
5