Table of Contents
Advertisement
TO CLEAN CHIMNEY OUTLET
(Boiler Model)
Remove baffle underneath the boiler cross flow
chamber by lifting it upwards and pulling it outwards
and insert cleaning brush. Replace baffle before
lighting fire.
When fitted correctly the baffle should fall forward to
close onto the bottom of the boiler. The appliance
will not function correctly with this baffle misaligned
or missing.
(Non Boiler Model)
Remove the fire bricks on each side. Remove sec-
ondary air pipe by removing the retaining screw on
left hand side. Remove the baffle by first lifting it up
and pulling it forward, then rotate it down around the
baffle supports. Replace the baffle, the firebricks
and the secondary air pipe before the fire is lit.
Ensure the secondary air pipe is sealed to the right
hand side with fire cement.
TO REPLACE FIRE GRATE
Remove the 3 fire fence at the front of the stove,
unscrew the pull rod knob from the pull rod bar locat-
ed at the front of the stove in the bottom left hand
corner. Pull the circular firegrate in the centre of the
stove upwards to the right as far as is possible.
Then twist the circular firegrate so that the front
edge is lifted up and the back edge is moved down
through the hole in the firebed insert. Push the cir-
cular firegrate down through the firebed insert.
The circular firegrate can then be removed by push-
ing it to the rear of the stove to relieve the pull rod
bar and then putting it out under the firebox insert.
The firebox insert can be removed by fitting the fire-
box insert up at the front, then rotate the firebox
insert until it can slide diagonally forward through the
opening in the front panel.
Replace any damaged parts and replace firebox
insert and grate ensuing that the pull rod is inserted
back through the opening on the left hand side of the
boiler and also through the hole on the front panel.
Replace the pull rod knob and the 3 fire fence before
relighting.
FIRE SAFETY
To provide reasonable fire safety, the following
should be given serious consideration.
1. Do not over fire the stove.
Fig.19
2. Overfiring will also damage painted or enamel
finish.
3. Install a smoke detector in the room.
4. A conveniently located class "A" fire extin-
guisher to contend with small fires resulting
from burning embers.
5. A practical evacuation plan.
6. A plan to deal with a chimney fire as follows:-
(a) Notify the fire department.
(b) Prepare occupants for immediate
evacuation.
(c) Close all openings into the stove.
(d) While awaiting the fire department watch
for ignition to adjacent combustibles from
overheated stove pipe or from embers or
sparks from the chimney.
VITREOUS ENAMEL CLEANING
General cleaning must be carried out when the
stove is thoroughly cool.
If this stove is finished in a high gloss vitreous
enamel, to keep the enamel in the best condition
observe the following tips:
1. Wipe over daily with a soapy damp cloth,
followed by a polish with a clean dry duster.
2. For stubborn deposits a soap impregnated
pad can be carefully used on the vitreous
enamel.
3. Only products recommended by the Vitreous
Enamel Association, these products carry
the Vitramel label.
17
Hide quick links:
Advertisement
Table of Contents
