To Clean Chimney Outlet - Boiler Model & Non Boiler Model; To Replace Damaged Grate Or Grate Bar - Boiler Model & Non Boiler Model; Fire Safety - Stanley Ashling Installation And Operating Instructions Manual

TO CLEAN CHIMNEY OUTLET
Boiler Model
Remove baffle underneath the boiler cross flow
chamber by lifting it upwards and pulling it outwards
and insert cleaning brush. Replace baffle before
lighting fire.
Non Boiler Model
Remove hob and place to one side, taking care not
to damage the enamel finish. Remove the hotplate
and inner top by unscrewing the four 1/4" hex head
bolts and insert the cleaning brush. Replace the
hotplate and inner top, ensuring that the rope on the
bottom of the inner top has not moved out of position
or been damaged. Replace the hob before relight-
ing the fire.
WARNING NOTE:
Properly installed, operated and maintained this
stove will not emit fumes into the dwelling.
Occasional fumes from the de-ashing and re-
fuelling may occur. However, persistent fume emis-
sion is potentially dangerous and must not be
tolerated. If fume emission does persist, then the
following immediate action should be taken:
(a) Open doors and windows to ventilate room.
(b) Let the fire out or eject and safely dispose of
fuel from the stove.
(c) Check for flue or chimney blockage and
clean if required.
(d) Do not attempt to relight the fire until the cause
of the fume emission has been identified and
corrected. If necessary seek expert advice.
The most common cause of fume emission is flue-
way or chimney blockage.
these must be kept clean at all times.
Fig.18
For you own safety
TO REPLACE DAMAGED GRATE OR GRATE
BAR
BOILER MODEL
Remove the two sets of side firebricks and the front
firebrick from the stove, taking care not to damage or
break the bricks in the process.
assembly up on the left hand side, and pull towards
the left hand side of the stove, until the front bar is
clear of the right hand side of the stove (See Fig.
19). Remove the grate bars from the firebox and
then remove the grate frame, replace the damaged
part and reassemble the grate system by firstly
replacing the grate frame, and the grate bars, and
replacing finally the firebricks.
NON - BOILER MODEL
Remove the front brick, the back brick, all the left
hand side bricks and both small right side bricks
from the stove, taking care not to damage or break
any of the bricks in the process.
assembly up on the left hand side of the stove and
pull towards the left side of the stove until the driven
rocker bar is clear of the right hand firebricks.
Remove the grate assembly from the firebox,
replace the damaged part and reassemble the fire-
box by repositioning the grate assembly and then
reposition all the firebricks.
Fig.19

FIRE SAFETY

To provide reasonable fire safety, the following
should be given serious consideration.
1. Do not over fire the stove.
2. Overfiring will also damage painted or enamel
finish.
3. Install a smoke detector in the room.
12
Tilt the grate
Tilt the grate