Canon ip110 series Online Manual page 412

The wireless channel to be used may be limited depending on wireless network devices installed in the
computer. Refer to the instruction manual provided with your computer or your wireless network device to
specify the valid wireless channel.
Make sure that the channel confirmed in Check 8 can communicate with the
Check9
computer.
If not, change the channel set to the access point.
Make sure that the firewall of the security software is disabled.
Check10
If the firewall function of your security software is turned on, a message may appear warning that Canon
software is attempting to access the network. If the warning message appears, set the security software to
always allow access.
If using any programs that switch the network environment, check their settings. Some programs will enable a
firewall by default.
When using a router, connect the printer and computer to the LAN side
Check11
(same network segment).
If the problem is not resolved, perform setup again with the Setup CD-ROM or perform it according to the
instructions on our website.
• For placement:
Make sure that there is no barrier or obstacle between the access point and the printer.
Note
• When you connect the printer to a Windows XP computer by cableless setup:
Follow the procedure below to perform settings of the printer and the computer.
1. Enable the access point mode of the printer.
2. Right-click the Wireless Network Connections icon on the notification area on the desktop,
then click View Available Wireless Networks.
3. Select the network name on the screen displayed, then click Connect.
Select "XXXXXX-iPXXXseries" ("XX" represents alphanumeric characters.) as the network
name.
4. Enter the network key on the screen displayed, then click Connect.
As a default, the serial number of the printer is used as a network key. Confirm the serial number
on the rear of the printer.
5. Perform setup with the Setup CD-ROM or perform it according to the instructions on our website.
Cannot Communicate with the Printer Using the Access Point Mode
Make sure that the printer is turned on.
Check1
Is the access point mode disabled?
Check2
Enable the access point mode following the procedure below.
1. Make sure that the printer is turned on.
412