Table of Contents
Advertisement
4.
Remove the water from the steam
generator with the sponge and rub it
dry.
11.4 The appliance door
4
3
WARNING!
The door is heavy.
3
60º
4
11.5 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
2
5
4
5.
Keep the door open to let the appli-
ance dry fully.
Remove the door to clean the inner side
of the appliance more easily.
Removing the appliance door
1.
Open the door as far as possible.
2.
Fully release the clamping levers on
the hinges.
3.
Hold the door on the two sides and
close it approximately 3/4 of the
way.
4.
Pull the door away from the appli-
ance.
CAUTION!
Put the door with the outer side
down on a soft and level surface.
Installing the appliance door
1.
Hold the door on the two sides at an
angle of approximately 60°.
2.
At the same time push the door
hinges as far as they can go into the
two recesses at the bottom of the
appliance on the left and the right.
3.
Lift the door up until you are at the
point of resistance and then open it
as far as possible.
4.
Fully lock the clamping levers on the
hinges.
5.
Close the door of the appliance.
Replacing the lamp on the left side of
the cavity:
1.
Remove the left shelf support.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
ENGLISH
19
Advertisement
Table of Contents
