Table of Contents
Advertisement
SECTION 8
APPLIANCES & INTERIOR FEATURES
One Place Monitor Panel
Water and Holding Tank Levels
Press and hold the switch to show approxi-
mate level on the monitor lights.
Approximate levels of the fresh water and
holding tanks are measured by sets of electronic
probes in the sides of the tanks. The liquid must
be at or above a probe to illuminate the indicator
lights to a given level.
For example, a water level of 1-2" above the
1/3 probe would register as only 1/3 full. Conse-
quently, a level of merely 1" below the 1/3 probe
would register empty. Generally speaking, there
is actually more liquid in a tank than indicated.
8-8
Tank Capacities
See back of "To The Owner" page inside
front cover of this manual.
LP Gas Level
Press and hold the switch to show approxi-
mate LP tank level.
The LP level is registered by a sending unit
on the tank. The gauge mounted on the side of
the tank will give a more accurate indication of
actual tank level if needed.
Water Pump Switch
When use of the self-contained water system
is desired, turn the "Water Pump" switch on. The
"Pump On" light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to "Fresh Water System" for additional
information on the water pump and initial start-
up.
Water Pump
Switch
Battery Voltage Meter
Push the button to check the level of charge
in the 12-volt house battery.
The LCD display will show the current bat-
tery voltage to the nearest tenth of a volt.
•
A 12-volt battery typically registers any-
where from 12.5V to 13V when adequately
charged.
Advertisement
Table of Contents
