Table of Contents
Advertisement
•
When 120 volts AC is available to the refrig-
erator, 'AC' will appear in the display panel,
indicating the refrigerator is operating on AC
electric.
•
If 120 volts AC is not available, the refriger-
ator will switch to the gas operation, and
'LP' will appear in the display panel.
During operation in the AUTO mode, when
a higher priority power source becomes avail-
able, the operating controls will cease using the
current power source and will switch to the
higher priority power source. For example, if
AC electric becomes available while the refrig-
erator is operating in the AUTO LP GAS mode,
APPLIANCES & INTERIOR FEATURES
the refrigerator will switch to AUTO AC opera-
tion.
If an operating mode is not functional, a
diagnostic code will appear and the refrigerator
will attempt to operate in a lower power priority
source. If a lower power priority source is not
available, an alarm will sound and the refrigera-
tor will cease operation. Refer to the Diagnostic
Codes and Their Meaning for corrective actions.
Start-Up Instructions - Manual Mode
To operate in the MANUAL mode, press and
hold the MODE button until AUTO disappears
and the desired operating mode is displayed. If
the power source is interrupted while operating
in the MANUAL mode, a diagnostic code will
appear, an alarm will sound, and the refrigerator
will cease operation. For corrective actions, refer
to the Diagnostic Codes and Their Meaning on
page 10 of the Norcold Operator's Guide in the
blue binder.
AUTO and MANUAL Modes - Gas Operation
Only
If the gas does not ignite within 30 seconds,
which may occur on initial start-up, the refriger-
ator's gas valve will automatically close and the
operating controls will select an alternate power
source (AUTO Mode) or revert to a stand-by
mode in which the LP GAS LED flashes. The
LED continues to flash until the refrigerator is
turned OFF and then ON. If the gas does not
ignite after several attempts, check the input gas
supply, or consult with your dealer or a Norcold
authorized service center. A different mode of
operation may be selected by pressing and hold-
ing the MODE button. The refrigerator will not
SECTION 8
8-3
Advertisement
Table of Contents
