Starting The Heat Pump - Samsung HHSM-G500005-1 Installation Manual

Before starting the heat pump make sure that all packaging is removed from the outdoor
unit, and that the system is free of any air.
To start the heat pump follow the description below.
1. Push the On/Off button on the top left hand side of the controller, 'AU' should now
appear on the controller, this means that the system is in Automatic mode.
2. Press the DHW power button. The DHW symbol
hand corner of the display.
3. Use the Mode button with the DHW section of the controller to change the Hot
Water to two dots.
4. Push the oval set button and use the + / - buttons
Hot water, we recommend that this is set to 48°C.
5. The pump symbol
pump is running.
6. After two minutes the cylinder symbol should appear
pump is ready for hot water preparation.
7. Within 3 minutes this symbol should appear
unit is now running.
8. The heat pump will prioritise Hot water, so allow the cylinder to reach temperature
before testing the heating circuit.
9. Turn up the room thermostats, once the cylinder is at tempetature the heat pump
should automatically change over onto space heating.
10. When the heat pump is in space heating mode the only symbols to be displayed
will be to show that the circulation pump is running and
the heat pump is running.
11. Check the flow temperatures by pushing the view button.
12. The system is now set and running.
should appear on the screen this indicates that the circulation

Starting The Heat Pump

will appear in the top right
to adjust the set point for the
, this shows that the heat
. This indicates that the outdoor
to show that
27