Samsung HHSM-G500005-1 Installation Manual page 17

Strong Wind
Blown Wind
When the Air to Water Heat Pump is running in heating mode, ice can begin accumulate
on the surface of the condenser.
To prevent ice from growing, the Heat Pump will go into defrost mode to melt the ice.
The water formed from the melted ice will fall to the base of the heat pump where it can
es-cape to ground through the drain holes in the base. This will require a drain pit or soak
hole beneath the Heat Pump to prevent water or ice from forming on the ground around
the Heat Pump which may be a safety hazard.
If installing the Heat Pump on a wall, the supplied drain plug and drain hose can be fitted
to pipe the water away to drain.
• If drain work is not enough, it can lead to
system performance degration
and system damages.
In case there is not enough space for drainage out of the unit, additional drain works are
required.Follow the description as below
• Make space more than 100mm between the bottom of the outdoor unit and the
ground for installation of the drain plug.•Insert the drain plug into the hole on the
bottom of the outdoor unit.
• Connect the drain hose to the drain plug.
• Make sure dusts or small branches should not go into the drain hose.
Strong Wind
• Considering the direction of
strong wind, the out-door unit shall
be installed. Strong wind can make
the unit turned over so need to set
side of the unit face the direction
of wind, not front.
17