Specifications - Yamaha HTR-6150 Service Manual

RX-V563/HTR-6150/DSP-AX563
I SPECIFICATIONS
I Audio Section
Minimum RMS Output Power (Power Amp. Section)
(1 kHz, 0.9 % THD)
FRONT L/R, CENTER, SURROUND L/R, SURROUND
BACK L/R
U, C models (8 ohms) .......................................... 90 W/ch
R, T, K, A, B, G, E, F, L models (6 ohms) ........... 90 W/ch
Maximum Power (JEITA) (1 kHz, 0.9 % THD, 6 ohms)
FRONT L/R, CENTER, SURROUND L/R, SURROUND
BACK L/R
R, T, K, L models ............................................... 115 W/ch
Dynamic Power Per Channel (IHF) (FRONT L/R drive)
U, C models
(8/6/4/2 ohms) ...................................... 90/110/130/150 W
R, T, K, A, B, G, E, F, L models
(6/4/2 ohms) .............................................. 100/110/125 W
Dynamic Headroom
U, C models (8 ohms) ............................................. 0.18 dB
Input Sensitivity/Input Impedance (1 kHz, 100 W / 8 ohms)
CD, etc. ............................................... 200 mV / 47 k-ohms
MULTI CH INPUT
FRONT L/R, CENTER, SURROUND L/R, SUBWOOFER
........................................................ 200 mV / 47 k-ohms
Maximum Input Signal (1 kHz, 0.5 % THD, Effect on)
CD, etc. .......................................................... 2.0 V or more
Output Level/Output Impedance
REC OUT .......................................... 200 mV / 1.2 k-ohms
SUBWOOFER (2ch STEREO and FRONT SP: Small)
................................................................ 4 V / 1.2 k-ohms
Headphone Jack Rated Output/Impedance
CD, etc. (1 kHz, 200 mV, 8 ohms) ....... 400 mV / 470 ohms
Frequency Response (10 Hz to 100 kHz)
CD, etc. to FRONT L/R .......................................... 0 / -3 dB
Total Harmonic Distortion (1 kHz, 50 W)
Direct to FRONT L/R SP OUT
U, C models (8 ohms) ................................. 0.06 % or less
R, T, K, A, B, G, E, F, L models (6 ohms) .. 0.06 % or less
Signal to Noise Ratio (IHF-A Network)
Direct STEREO to Input shorted SP OUT
200 mV ........................................................ 98 dB or more
250 mV ...................................................... 100 dB or more
Residual Noise (IHF-A Network)
FRONT L/R SP OUT .................................... 150 µV or less
Channel Separation
CD, etc. (Input 5.1 k-ohms shorted, 1 kHz / 10 kHz)
......................................... 60 dB or more / 45 dB or more
Tone Control Characteristics
BASS
Boost/Cut ................................................ ±10 dB (100 Hz)
TREBLE
Boost/Cut ................................................ ±10 dB (20 kHz)
Filter Characteristics
FRONT, CENTER, SURROUND, SURROUND BACK small
(H.P.F.)
....... fc=40/60/80/90/100/110/120/160/200 Hz, 12 dB/oct.
SUBWOOFER (L.P.F.)
....... fc=40/60/80/90/100/110/120/160/200 Hz, 24 dB/oct.
10
I Video Section
Video Signal Type
Gray back
U, C, R, K models .................................................... NTSC
T, A, B, G, E, F, L models .......................................... PAL
Video conversion
......................................................................... NTSC/PAL
Composite Video Signal Level
.................................................................. 1 Vp-p / 75 ohms
S-Video Signal Level
Y ............................................................... 1 Vp-p / 75 ohms
C ........................................................ 0.286 Vp-p / 75 ohms
Component Signal Level
Y ............................................................... 1 Vp-p / 75 ohms
Pb/Pr ...................................................... 0.7 Vp-p / 75 ohms
Video Maximum Input Level
.................................................................. 1.5 Vp-p or more
Signal to Noise Ratio
....................................................................... 50 dB or more
Monitor Out Frequency Response
Component video signal .................. 5 Hz to 60 MHz, -3 dB
HDMI ........................................................................ Ver. 1.2a
I FM Section [U, C, R, T, K, A, G, E, F, L models]
Tuning Range
U, C models ............................................ 87.5 to 107.9 MHz
R, L models ............... 87.5 to 108.0 / 87.50 to 108.00 MHz
T, K, A, G, E, F models ...................... 87.50 to 108.00 MHz
50dB Quieting Sensitivity (IHF) (1 kHz, 100 % Mod.)
Mono ......................................................... 2.8 µV (20.2 dBf)
Signal to Noise Ratio (IHF)
Mono / Stereo ................................................. 73 dB / 70 dB
Harmonic Distortion (1 kHz)
Mono / Stereo ................................................. 0.5 % / 0.5 %
Antenna Input .................................... 75 ohms unbalanced
I AM Section [U, C, R, T, K, A, G, E, F, L models]
Tuning Range
U, C models .............................................. 530 to 1,710 kHz
R, L models ....................... 530 to 1,710 / 531 to 1,611 kHz
T, K, A, G, E, F models ............................ 531 to 1,611 kHz
Antenna Input ................................................. Loop antenna
I General
Power Supply
U, C models ............................................... AC 120 V, 60 Hz
R model ................. AC 110, 120/220, 230-240 V, 50/60 Hz
T model ..................................................... AC 220 V, 50 Hz
K model ..................................................... AC 220 V, 60 Hz
A model ..................................................... AC 240 V, 50 Hz
B, G, E, F models ...................................... AC 230 V, 50 Hz
L model ................................. AC 220, 230-240 V, 50/60 Hz
Power Consumption
U, C models ................................................ 240 W / 320 VA
R model .................................................................... 260 W
T, K, A, B, G, E, F, L models .................................... 240 W