Table of Contents
Advertisement
I.
iPod
This menu is used to test the DOCK connector without the iPod itself. After turning off the power to this unit short
between pins No. 14 (TX) and No. 18 (RX), between pins No. 1 (PWR) and No. 17 (ACCPOW), between pins No. 4
(iPDET) and No. 8 (DGND) and between pins No. 21 (DKID) and No. 8 (DGND) of the DOCK connector. (Make sure
that the power is turned off when shorting pins.)
Start the self-diagnostic function and select this menu.
The check result is displayed according to the following display specifications.
Note) Be sure to return the shorted pins to their original condition after executing this test.
15
16
9
10
11
12
3
4
5
6
1
19
20
DOCK CONNECTOR
Check item
UART loop back test
iPAP (iPod accessory power) detection
iPDET (iPod installation to DOCK) detection
DKID (DOCK ID) detection
DOCK ignore
When DOCK and iPod are connected, the input source [DOCK (iPod)] is made ineffective and [V-AUX] is selected.
Bluetooth version
When the Bluetooth DOCK is connected, the firmware version of that Bluetooth module is displayed.
17
18
13
14
7
8
2
21
Result
OK
NG
IC83
High
pin No.5
Low
IC82
Low (iPod universal dock)
pin No.5
High (Bluetooth adapter)
IC82
10 k-ohms, 1/4 W pull down
pin No.4
Other
I2.DOCK IGNORE
I3.BTYS:x.xxx
RX-V563/HTR-6150/DSP-AX563
I1.DOCK:NG NNN
All Y = "OK"
Others = "NG"
Display
Y
N
Y
N
Y
N
Y
N
33
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
