Pioneer DEH-P7000BT Operation Manual page 88

(~I_"_st_a_lI_a_t i _o_"~~_~_) (~ E"~g~li_s_h ) (~I_"_st_a_lI_a_ti_o_n~~~~~)
(
E_"g=-I_is~h
)
Adjusting the microphone
angle
The microphone angle can be adjusted by
moving forward or backward the microphone
clip angle.
Clamps
Use clamps to secure
the lead where
necessary inside the
vehicle.
Fit the
microphone lead
into the groove.
""'i!!~s./
~
~~
Install the microphone clip on the
rear side of the steering column .
2. Install the microphone clip on the
steering column.
Double-sided tape
Microphone clip
~
When installing the microphone
on the steering column
1. Install the microphone on the
microphone clip.
[
Clamps
Use clamps to secure
the lead where
necessary inside the
vehicle.
4CAUTION
When installing the microphone
on the sun visor
1. Install the microphone on the
microphone clip.
~"OPhO",
~
Mi=pho", dip
2. Install the microphone clip on the
sun visor.
• With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the
recognition rate for voice operations.)
, Microphone clip
F=,,~~
'2
• It is extremely dangerous to allow the microphone
lead to become wound around the steering
column or gearstick. Be sure to install the unit in
such a way that it will not obstruct driving.
Installing the microphone
Installation notes
Install the microphone in a position and
orientation that will enable it to pick up the
voice of the person operating the system.
3. Flip the holders into upright
positions.
2. Replace the front panel to the unit.
4. Fix the front panel to the unit using
screws.
I/~--I
Fastening the front panel
If you do not plan to detach the front panel,
the front panel can be fastened with supplied
screws and holders.
1. Attach the holders to both sides of
the front panel.