Pioneer DEH-P7000BT Operation Manual page 30

Section
. . ( Operating this unit
S Select PAIRE FROM PHONE and then
press MULTI-CONTROL to ready for pairing.
READY
will be displayed.
6 Use your cellular phone to establish
connection.
PIN code is set to
0000
as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection
on page 48.
While connecting,
CONNECTING
is displayed.
If the connection is established,
COMPLETED
is displayed.
After connected, this unit automatically
changes to
PH. BOOK DL
(phone book down-
load confirmation) display.
• If the connection fails,
ERROR
is displayed. In
this case, check the cellular phone and try again.
• If three cellular phones have already been
paired, the pairing assignment selection display
will appear. Select one assignment to pair the
new phone. The newly paired phone overwrites
the previously paired phone. The assignment se-
lection operation is the same as Step 3 to 4 of
Pairing
a
connected cellular phone
on the next
page except for the operation below.
• Switching the SO address and device name
7 Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push
MULTI-CONTROL
left or rig ht to select
NO
(No) or
YES
(Yes).
Press
MULTI-CONTROL
to decide.
When you select
YES,
this unit changes to
PH BOOK DOWNLOAD
and the download op-
eration automatically begins. After complet-
ing,
DATA DOWNLOADED
is displayed.
According to the circumstances, this unit
changes to
PH BOOK TRANSFER.
In this case,
refer to step 4 on
Transferring entries to the
phone book
on page 39.
• When you select
NO,
the display reverts to
normal.
00
En
)
Using this unit to initiate a connection
1
Display the connection menu.
Refer to
Introduction of connection and regis-
tration
on the previous page.
2 Use MULTI-CONTROL to select
8T HANDS FREE.
3 Use MULTI-CONTROL to select a group.
Push
MULTI-CONTROL
up or down to select a
group.
NOKIA (Nokia)-STANDARD
(standard)
• Normally select
STANDARD.
If the device of
Nokia is not paired to this unit, select
NOKIA.
• Push
MULTI-CONTROL
left or right to display
a group name or an 10.
4 Press MULTI-CONTROL to switch to
PAIRE FROM PHONE.
Push
MULTI-CONTROL
up or down to switch
PAIRE FROM PHONE
and
SEARCH DEVICE.
S Select SEARCH DEVICE and then press
MULTI-CONTROL to start searching.
While searching,
SEARCHING
is displayed.
• If this unit fails to find any available cellular
phones,
NOT FOUND
is displayed.
6 Use MULTI-CONTROL to select a device.
Push
MULTI-CONTROL
up or down to select a
device name you want to connect.
Press
MULTI-CONTROL
to select a device
name.
• Push
MULTI-CONTROL
left or right to switch
the SO address and device name.
7
Use your cellular phone to establish
connection.
PIN code is set to
0000
as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection
on page 48.
While connecting,
CONNECTING
is displayed.
If the connection is established,
COMPLETED
is displayed.
After connected, this unit automatically
changes to
PH. BOOK DL
(phone book down-
load confirmation) display.