Use Of A Locking Clip - Peg-Perego Primo Viaggio SIP Convertible Instructions For Use Manual

Installing your child restraint in the vehicle - Rear Facing mode
6. The picture shows the correct belt path
when the child restraint is attached to the
6
vehicle using a lap/shoulder belt.
Make sure the child restraint is properly
leveled as explained on page 28.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the UAS anchors.

USE OF A LOCKING CLIP

If the lap/shoulder belt in your vehicle requires
a locking clip according to page 19, the Primo
Viaggio SIP Convertible is provided with one
in the tether compartment (page 12).
To install the locking clip, hold the shoulder
strap and lap belt together just above the
buckle. Unbuckle the belt while holding the
straps. Hook the locking clip around both
straps as shown.
Leave 1/2 inch space between the clip and
latch. Re-buckle the belt.
- 34 -