Table of Contents
Advertisement
Connection to any IBM
VGA PC and APPLE
Macintosh PC
Connecting the Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then follow
these steps:
1
Power off both the monitor and computer.
1'
To adjust height of your monitor, unlock the stand lock on top of the
stand. Push the stand lock at arrows shown (Applies to 577LH only).
2
Connect one end of the monitor signal cable to the input connector
on the rear panel of the monitor.
3
Connect the other end to the 15-pin connector on the real panel of
the computer and tighter the screws. Be sure the signal cable aligns
with the 15-pin connector.
3'
Connect the other end of the monitor signal cable to the rear panel of
Macintosh computer through a Macintosh adapter and then tighten
screws.
4
Connect the plug from the AC adapter into the base of the monitor .
Connect one end of the AC power cord to the AC adapter
other end to a properly grounded AC outlet that is easily accessible
and close to the monitor .
5
Power on the computer, then the monitor.
6
If you see the NO SIGNAL message, check the signal cable and
connectors.
7
After using the system, power OFF the monitor, then the computer.
Note : If you see the "OUT OF RANGE" message, check to make sure your system is
set to one of the factory preset modes (see page A14), or is set to a resolution and
refresh rate within the specification limits of this monitor.
3
2
Power Cord
A4
3
Stand Lock
1'
IBM
D-15P
24V
1
AC adapter
Installation
1
and the
2
MACINTOSH
3'
Adapter 15P
3
Signal cable
Advertisement
Table of Contents
